Hotchkiss drive
The Hotchkiss drive represents a type of shaft-driven power transmission that was the prevailing choice for front-engine, rear-wheel drive layout vehicles throughout much of the 20th century. Although named after the French company Hotchkiss, earlier versions of comparable mechanisms were implemented by manufacturers such as Peerless.
During the early 1900s, the Hotchkiss drive faced competition from chain-driven systems and the torque tube, which remained widely used until the 1950s. A principal engineering challenge involved controlling axle torque—the rotational force causing the drive axle to turn counter to the wheels—and managing braking forces that push the axle in alignment with wheel rotation.
Typically, shaft-drive configurations feature a drive shaft running from the transmission to the rear differential. What sets the Hotchkiss drive apart is its rigid connection of the axle housing directly to the leaf springs, allowing axle torque to be transmitted through these springs into the vehicle chassis. This design incorporates universal joints at both ends of an exposed driveshaft, enabling the use of straightforward cross-type universal joints due to correct phasing and parallel alignment. By comparison, torque tube designs utilize a single universal joint and secure the axle housing via a torque tube linked to the transmission.
To prevent thrust forces from traveling backward along the driveshaft from the axle, Hotchkiss drives employ slip-splines or plunge-type joints. This facilitates uncomplicated rear-axle location using parallel leaf springs. Conversely, torque-tube arrangements transfer such thrust forces through the torque tube to engine and transmission mounts attached to the frame. When combined with rear coil springs—as seen in vehicles like the 1938–62 Buick—torque-tube systems require supplementary locating components such as a Panhard rod. However, this additional hardware is unnecessary when paired with leaf springs, exemplified by early Ford models and Buicks from 1906–1937.
In certain applications, Hotchkiss driveshafts are constructed in two segments with a central universal joint to enhance flexibility; this configuration is prevalent in trucks and specialized vehicles including fire engines. To diminish noise and vibration, rubber mounts may be incorporated—for instance, the 1984–1987 rear-wheel-drive Toyota Corolla coupe featured a two-piece Hotchkiss driveshaft supported by a rubber-mounted center bearing.
This architecture dominated automotive design from roughly the 1920s until the 1970s and continues to be widely utilized in pick-up trucks and sport utility vehicles as of 2016.
Managing braking forces is equally important as transmitting power. While accelerating, axle torque acts counter to wheel rotation; during braking, it aligns with wheel rotation. The solid attachment of the axle housing to leaf springs efficiently conveys both acceleration and braking torques into the vehicle frame.
It is important to note that there is no association between the Hotchkiss drive and either suspension component manufacturer Hotchkis or racing driver Tom Hotchkiss.